Vivotek IP7153 Specifikace stáhnout pdf (Strana 6)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

6 - User's Manual

Hardware Reset

The reset button is used to reset the system or restore the factory default settings� Sometimes

resetting the system can return the camera to normal operation� If the system problems remain

after reset, restore the factory settings and install again�

Reset: Press and release the indented reset button with a paper clip or thin object� Wait for the

Network Camera to reboot�

Restore: Press and hold the reset button until the status LED rapidly blinks� It takes about 30

seconds� Note that all settings will be restored to factory default� Upon successful restore, the

status LED will blink green and red during normal operation�

Installation

Hardware Installation

Follow the steps below to mount the lens to the Network Camera:

1� Mount the lens by turning it clockwise onto the camera mount until it stops� If necessary, turn

the lens counterclockwise slowly until it gets the best attitude�

2� Connect the lens cable plug to the camera connector�

3� Unscrew the zoom controller to adjust the zoom factor� Upon completion, tighten the zoom

controller�

4� Unscrew the focus controller to adjust the focus range� Upon completion, tighten the focus

controller�

Status LED

Recessed Reset Button

∞

1 2 3 4 5 6 7 8 9 10 11 ... 147 148

Žádné komentáře

Vivotek IP7153 Specifikace Strana 6