Vivotek IP8162 Specifikace Strana 8

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 199
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 7
VIVOTEK
8 - User's Manual
Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the
Network Camera to reboot�
Restore: Press and hold the recessed reset button until the status LED rapidly blinks. Note that
all settings will be restored to factory default� Upon successful restore, the status LED will blink
green and red during normal operation�
SD/SDHC Card Capacity
This network camera is compliant with SD/SDHC 16GB / 32GB and other preceding standard
SD cards�
Installation
Hardware Installation
Follow the steps below to mount the lens to the Network Camera:
1� Mount the lens by turning it clockwise onto the camera mount until it stops� If necessary, turn
the lens counterclockwise slowly until it gets the best attitude�
2� Connect the DC-iris control cable to the socket� (IP8162)
Connect the P-iris control cable to the socket� (IP8162P)
1
2
Status LED
Recessed Reset
Button
Zobrazit stránku 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 198 199

Komentáře k této Příručce

Žádné komentáře